VARI❋LITE® - VL1000™ ERS LUMINAIRE USER’S MANUAL
24 25-Feb-02 02.9663.0001
Standard Power Up Procedure
Use this procedure when powering up a luminaire that has already been configured.
(Refer to “Power-Up and Configuration Overview” on page 23.)
Note: Refer to Chapter 4: Menu System for detailed instructions on menu functions.
CAUTION: Before applying power, be sure the luminaire is hung or positioned so
that the head and yoke can move freely without restriction.
To power up luminaire:
Step 1. At each luminaire, apply power by switching on power source. Luminaire
will display Starting for 10-15 seconds, and then automatically step
through the following procedure:
a. For Arc lamps:
1) If Lamp Power-Up State is set to Lamp On, lamp will strike (ignite).
2) Luminaire will cycle through calibration and stop at "home" position.
3) If Lamp Power-Up State is set to Cal On, lamp will strike (ignite) at
end of calibration sequence.
b. For Incandescent lamps:
1) Luminaire will cycle through calibration and stop at "home" position.
Commentaires sur ces manuels